Siemens SITRANS LG240 Operating Instructions Manual page 12

Flanges
Electronics module
Centering
Rod components
12
It is suitable for measured value indication and adjustment of sensors
and is connected to the sensor with a four-wire standard cable up to
50 m (164 ft) long.
You can find additional information in the operating instructions
manual "LG Remote Interface".
Screwed flanges are available in different versions according to the
following standards: DIN 2501, EN 1092-1, ASME B 16.5, JIS B 2210-
1984, GOST 12821-80.
You can find additional information in the supplementary instructions
manual "Flanges according to DIN-EN-ASME-JIS" (Document-ID
47574).
The electronics module SITRANS series LG is a replacement part for
TDR sensors of SITRANS series LG. There is a different version avail-
able for each type of signal output.
You can find further information in the operating instructions manual
"Electronics module SITRANS series LG".
If you mount the SITRANS LG240 in a bypass tube or standpipe, you
have to avoid contact to the bypass tube by using a spacer at the
probe end.
You can find additional information in the operating instructions
manual "Centering".
If you are using an instrument with rod version, you can extend the
rod probe individually with rod extensions of different lengths or seg-
ment it for difficult installation situations.
All extensions used must not exceed a total length of 4 m (13.12 ft).
The extensions are available in the following lengths:
Rod ø 8 mm (0.315 in)
•
Basic segment: 450 mm (17.72 in)
•
Rod segments: 450 ... 480 mm (17.72 ... 18.9 in)
•
End segment: 26 ... 480 mm (1.02 ... 18.9 in)
You can find further information in the operating instructions manual
"Rod and cable components SITRANS series LG".
SITRANS LG240 - Operating Instructions PBD-51041038