Operation - Panasonic FV-28RNQL1 Operating And Installation Instructions

OPERATION

WHEN TO TURN ON THE RANGE HOOD?
Turn on the Range Hood at least one minute before starting to cook to direct fumes and vapours
towards the suction surface.
After cooking, leave the Range Hood operating until complete extraction of all vapours and odours.
By means of the Timer function, it is possible to set auto switch-off function which will allow
the Range Hood to turn off automatically after 15 minutes of operation.
WHICH SPEED IS TO BE SELECTED?
1st speed : disposal of odours and vapours with low electricity consumption.
2nd speed : normal conditions of use.
3rd speed : presence of strong odours and vapours.
4th speed : rapid disposal of odours and vapours.
WHEN SHOULD THE FILTERS BE WASHED?
It is advised to wash the metal filters every 30 hours of operation.
For further details refer to the "MAINTENANCE" section.
ELECTRONIC PUSHBUTTON PANEL
Motor ON / OFF
Upon start-up, the speed is that stored at the previous operation.
Increase speed from 1 to 4
Speed 4 is only active for 7 minutes,
speed 3 activates.
Reduce speed from 4 to 1
Light on / o
TIMER
( red LED flashing)
Auto switch-o after 15 min.
This function can be activated only if the motor is already active with
any speed when the key is pressed.
The function deactivates (red LED o ) if :
- The TIMER key (
- The ON / OFF key (
FILTER ALARM
The RED lighting indicates that the metal lter alarm is active (after
30 hours); to deactivate this alarm and reset the hour meter, press the
key ( ) for 3 seconds.
The speeds are indicated by the LEDs
on the keys :
("+" LED flashing)
) is pressed again.
) is pressed.
(red LED steady on with (
Speed 1
Speed 2
Speed 3
Speed 4
9