Filling The Tank With Water - Panasonic EH-HS60 Operating Instructions Manual

Filling the tank with water

1
1
Pull the tank straight out in a slightly upward
direction, while pressing buttons on both sides
of the tank.
2
2
Open the plug of the tank and
soak the felt part inside of the
cap (about 5-6 seconds).
•
The hair straightener may have
difficulty releasing steam if the felt
is dry. In this case, thoroughly soak
the felt (approximately 10 minutes)
before use.
3
3
Fill the tank with water, and then securely
attach the plug.
•
Use only tap water. (Use of other types of water may
damage the hair straightener.)
•
Be sure not to let dirt get between the plug and tank.
(Dirt may cause water leakage.) Wipe off excess
water before attaching the tank. (Excess water may
cause hot water droplets to be generated.)
4
4
Align the tank with the end of the hair
straightener and attach it from above.
5
5
Push the tank in until a click is heard.
Notes

•
Note that the surface of the hair straightener becomes
hot if used without water.
•
The hair straightener can be used for approximately
10 minutes on a full tank of water.
•
Before attaching the tank to the hair straightener, be
EH-HS60_CH.indb 11
sure to shake the hair straightener - times with the
open (tank) end facing down to drain out any water.
Hot water droplets may be discharged if water
remains in the hair straightener.
•
Replacement of the tank block is suggested after one
year (due to clogging of the felt inside the cap).
Replacement parts are available at your dealer.
Using the hair straightener
1
1
Brush your hair to take out any tangles.
•
This prevents hairs from being cut.
2
2
Set the switch to "2". Once steam is released,
take a bundle of hair and clamp it with the
press plate underneath the hair.
•
When straightening bundles of hair at - cm widths,
pull gently. However, do not take much hair as it may
be difficult to straighten your hair.
•
Clamp the bundle of hair in the center of the iron
plate.
•
Be sure to fill the tank with water when using the hair
straightener at the "" setting.
•
Use both hands and hold the press plate to straighten
curly hair. Do not use excessive force as it may place
a strain on hair ends.
11
2009/05/28 20:23:03