Maintenance; Troubleshooting; Transportation, Storage And Disposal - Husqvarna WT 15i Operator's Manual

2. Push the start stop button to start the product.
To stop the product
• Push the start stop button to stop the product.
To clean the battery
CAUTION: Do not clean the battery with
water.

Troubleshooting

Problem
The LED on the product flashes and
the product does not start.
The LED on the product flashes dur-
ing operation.
The product does not move water
when it starts but the pump operates.
The product does not move water
when it starts and the pump does not
operate.
Low water flow from the machine.
The product can be used with a number of different
power cutters and core drills on the market.
Transportation of the product
• Attach the product during transportation to prevent
transport damage and accidents.
• Always stop the product and disconnect the power
cord before you move the product.
• Always disconnect the battery before transportation.
Storage of the product
• Keep the product in a locked area to prevent access
for children or persons that are not approved.
• Keep the product in a dry area.
• Remove the battery before storage.
1572 - 005 - 23.06.2021

Maintenance

Troubleshooting
Cause
Battery is not charged.
Low battery voltage.
Air bubbles in the pump container.
Blocked filter in the pump holder.
Blockage in the pump or blocked fil-
ter.
Frozen water in the pump.
Blocked filter in the pump holder.

Transportation, storage and disposal

Note: The pump stops automatically if the container runs
out of water
• Clean the battery terminals with compressed air or
use a soft and dry cloth.
• Clean the surfaces of the battery with a soft and dry
cloth.
Solution
Charge the battery.
Charge the battery.
Wait 1 minute and start again.
Remove and clean the pump.
Remove and clean the pump.
Put the product in a warm location
and let the frozen water melt.
Remove and clean the pump.
This product is not recommended for high performance
products that use high water flow and high water
pressure, for example concrete chain saws.
• Make sure that the temperature is not lower than
-25°C (-13°F) and not higher than 50°C (122°F).
Disposal
Symbols on the product or the packaging of the product
indicate that this product cannot be handled as domestic
waste. It must be submitted to an appropriate recycling
station for the recovery of electrical and electronic
equipment.
Make sure to disconnect the propane tank and remove
the battery from the product before submitting to an
7