Table of Contents
Advertisement
Modify Your System
Adding the Trigger Input Pod
5. Plug the connector attached to the ribbon cable into the appropriate 16-pin socket on the
6. Carefully refit the side panel. Start with the three screws located nearby the front panel, which
7. Plug the module into the mainframe again and fasten the module
8. Re-connect all cables disconnected during step 2
Figure 33
Trigger Input Pod
Replacement
Call the HP support if you need additional probe leads. The required part number is16520-62102.
You need to remove the leads from the probe adapter header before plugging them into the pod
housing.
62
E4805A board
are the shorter ones
Plug this connector
into the E4805A
module
2 Ground Pins
Input 0
8 Trigger Input lines
Input 7
Advertisement
Table of Contents
