3.4
Wiring of the module
Requirement
• The I/O modules are installed on the mounting rail.
• The supply voltage of the station is switched off.
Procedure
1. Plug the two SIMATIC TOP connect connecting cables with the 40-pin IDC connector into
X10 and X11.
Note when plugging:
– ① The nob on the left edge of connector X11
– ② The nob on the right edge of connector X10
2. Guide the SIMATIC TOP connect connecting cables down to the module.
3. Guide a cable tie around the module at the fixing points and connect the SIMATIC TOP
connect cables.
Digital input/output module DI 32x24VDC SNK/SRC/DQ 32x24VDC/0.3A SNK BA (6ES7523-1BP50-0AA0)
Equipment Manual, 07/2020, A5E48027024-AA
Figure 3-3
Connect the SIMATIC TOP connect 40-pin connecting cable to the module
Wiring
3.4 Wiring of the module
17