inch flange head capscrews and flange nuts. Use the
(2) 3/8-16 x 3 inch flange head capscrews in front
mounting holes (Figure 13).
7
Connect Wires
No Parts Required
Procedure
1. Plug rear harness into connector from front harness.
2. Plug the connector from the lift into the lift harness.
3. Connect ground wire from lift to engine ground.
4. Remove nut from positive battery clamp, insert
positive wire from lift onto cable clamp screw and
loosely secure with nut.
1. Positive lift wire
5. Make sure wiring is clear of all hot or rotating parts.
Secure with cable ties as required.
8
Reinstall Hood and Reconnect
Battery
No Parts Required
Procedure
1. Reinstall hood to frame.
G006705
Figure 14
2. Positive battery cable
clamp
2. Reinstall shroud, seats, seat frame and console cover
plate, if applicable.
3. Reinstall overflow tube to radiator. Check coolant
level and replenish, if required.
4. Reinstall positive battery cable to battery.
5. Slide rubber boot over positive terminal to prevent
possible short-out from occurring.
9
Mount Circular Bubble Level
Parts needed for this procedure:
1
Circular Bubble Level
Procedure
Affix circular level to top of console cover positioning
as shown in Figure 15.
1
1. Circular level
12
2
G010218
Figure 15
2. Operation decal