Table of Contents
Advertisement
Chapter 1 Installing the DSB-R100
1-1 Hardware installation
(1). Plug DSB-R100 USB flat connector into the USB port
of your PC. If the PC has a sound card, plug the
DSB-R100's RCA cable into the existing LINE IN
port of the sound card. If not, plug the RCA jack into
any speakers. Note that the recording function is not
available when running DSB-R100 software in this
way.
(2). The computer will detect DSB-R100 and look for a
driver. If a driver is not found, it will then prompt for
one. At this time, make sure that your DSB-R100
diskette is inserted into your computer floppy drive.
(3). The computer is now ready to install the DSB-R100
driver from floppy the drive.
12
Advertisement
Table of Contents
