Page 2
Serial number: ___________________________________ Date of purchase: ________________________________ Place of purchase: ________________________________ Acer and the Acer logo are registered trademarks of Acer Incorporated. Other companies’ product names or trademarks are used herein for identification purposes only and belong to their respective companies.
Information for your safety and comrt Safety instructions Read these instructions carefully. Keep this document for future reference. Follow all warnings and instructions marked on the product. Special notes on LCD monitors The following are normal with the LCD monitor and do not indicate a problem. •...
and to protect it from overheating. These openings must not be blocked or covered. The openings should never be blocked by placing the product on a bed, sofa, rug or other similar surface. This product should never be placed near or over a radiator or heat register, or in a built-in installation unless proper ventilation is provided.
We at Acer are very conscious of the environmental effects of our business and strive to identify and provide the best working procedures to reduce the environmental impact of our products.
LCD pixel statement The LCD unit is produced with high-precision manufacturing techniques. Nevertheless, some pixels may occasionally misfire or appear as black or red dots. This has no effect on the recorded image and does not constitute a malfunction. Power management statement should be as below. •...
Page 7
Take short breaks regularly and often. • Perform some stretching exercises. • Breathe fresh air as often as possible. • Exercise regularly and maintain a healthy body. Acer monitor is purposed for video and visual display of information obtained from electronic devices.
Page 8
(“x” = 0~9, a ~ z, A ~ Z, or blank) We, Acer Incorporated, hereby declare under our sole responsibility that the product described above is in conformity with the relevant Union harmonization legislations as below Directive and following harmonized...
Page 9
Acer America Corporation 333 West San Carlos St., San Jose Suite 1500 CA 95110, U. S. A. Tel : 254-298-4000 Fax : 254-298-4147 www.acer.com Federal Communications Commission Declaration of Conformity This device complies with Part 15 of the FCC Rules. Operation is subject to the following...
Table of Contents Information for your safety and comrt ................ii Safety instructions .......................ii Special notes on LCD monitors ..................ii Cleaning your monitor ..................ii Accessibility ......................ii Safe listening ......................ii Warnings ......................ii Using electrical power ..................iii Product servicing ....................iii Potentially explosive environments ..............iv Additional safety information ..................iv IT Equipment Recycling Information ................iv Disposal instructions ....................iv...
Page 11
Hot key2 (default: Brightness) ................. 14 Hot key3 (Selecting the input) ................. 15 Main Menu ....................... 15 Troubleshooting .......................23...
You can also adjust the monitor’s height within +/- 115 mm. Height Adjustment 115mm Note: Please adjust the height of the monitor afer pressing the top of the monitor. Tilt -5° 20° PE320QK User Guide English...
Lift the monitor to the highest position. Tilt the monitor to its maximum angle. Pivot the monitor clockwise to the angle you need. Warning: Don’t turn the pivot if a hood is attached to the screen. 115mm 90° 90° 90° 90° PE320QK User Guide English...
Picture 2, until the hooks are tightly locked in place. Repeat the same procedure to set up the other hood leaf Picture 2 Top cover of Shading hood installation complete. PE320QK User Guide English...
Page 16
Align the screw holes on the side of monitor. Use screwdriver or coin to fasten screw and fix door on the head. Repeat the same process to fix door on the other side. PE320QK User Guide English...
Page 17
Use fingers to push up under cover. Slide small door to the end as shown in the direction of the picture. * How to close top small door Slide small door back to the end. Push down to lock the door. PE320QK User Guide English...
The single toggle button on the backside of the Display bezel operates like a joystick. To move the cursor, simply toggle the button in four directions. • Press the button to select desired option. Note: Green indicates operable. Grey indicates inoperable. PE320QK User Guide English...
Audio output is only for audio output model. Please check user manual for more instruction. FreeSync (HDMI/DP): It can allow a FreeSync supported graphics source to dynamically adjust display refresh rate based on typical content frame rates for power efficient, virtually stutter free and low-latency display update. PE320QK User Guide English...
The power saving states will be kept until a control signal has been detected or the keyboard or mouse is activated. The recovery time from Active OFF state back to ON state is around 3 seconds. PE320QK User Guide English...
Rec.709 User Graphics Standard Movie Move Hot key2 (default: Brightness) Open the Brightness control and select your preferred brightness setting. When you are done, press the joystick to quit current page and store. Brightness Adjust PE320QK User Guide English...
Note: Set to “On”, will be based on the current screen to dynamic contrast adjustment. • HDR: Can control On, Off and Auto, set to Auto will automatically detect and deal with HDR signal. Auto: Auto checked source status. On: Support HDR effect. Off: No support HDR effect. PE320QK User Guide English...
Page 27
Decreases the color temperature. The screenappears cooler with a blue tint. Bluelight: Decreases the level of blue light emitted from the screen to make viewing more comfortable for your eyes. User: Allows you to manually adjust the color settings. PE320QK User Guide English...
Page 28
Note: There are three modes to correspond to the color space: Modes = sRGB(sRGB) Modes = Rec.709(Rec.709) Modes = HDR(HDR) • Grayscale Mode: Select garyscale mode “On” or “Off”. On: Color only black and white effect. Off: Normal color effect. PE320QK User Guide English...
Page 29
(EBU / DCI / SMPT-C) and modes = "standard" are shared parameter values, that can be adjusted and saved. CIE 1931 positive and negative error of 0.03, ("HDR" according to current Panel to fine-tune). N/A means to follow the current parameter value (Ex. Blue Light parameter value). PE320QK User Guide English...
Page 30
(a) Extreme (b) Normal (c) Off. • Refresh Rate Num: Display the panel’s current refresh rate on the screen. Note: If FreeSync set "On" you can see the V Frequency to changes in the OSD. PE320QK User Guide English...
Page 31
• PIP/PBP: Select to set PIP/PBP. • Hotkey Assigment: Select the function of shortcut key 1(Modes, Brightness, Volume, Gamma, Contrast, Blue Light, Over Drive,PIP/PBP) and shortcut keys 2 (Modes, Brightness, Volume, Gamma, Contrast, Blue Light, Over Drive,PIP/PBP) PE320QK User Guide English...
Page 32
• Quick start mode: Select Off or On. Turn on to speed up boot speed. • LED Control: Controls the brightness of the Key LED. • USB 3.0: Default is “Off”.You can choose "On",when resolution support 3840x2160-30Hz. (DP ALT only). • Power-off USB charge: Turn On or Off. PE320QK User Guide English...
Check if the AC power cord is properly connected to the monitor. Amber Check if the video signal cable is properly connected at the back of monitor. Check if the computer system is switched on and in power saving/standby mode. PE320QK User Guide English...