Canon VIXIA GX10 Instruction Manual page 105

Camera Access Point
In this mode the camcorder itself serves as a wireless access point to which other Wi-Fi-enabled devices can
connect. Initially, basic settings for a Camera Access Point connection (network name (SSID): [GX10-xxxx-
xx_Canon0C], password: [12345678]) are already saved under network configuration profile [1:]. You can use
the default settings to connect immediately to the camcorder or follow the procedure below if you wish to
change the settings.
Operating modes:
1 Select [Connection Settings].
> [B ! System Setup] > [Network Settings] > [Connection Settings]
2 Select the desired network configuration profile and then select [Camera Access Point].
Network configuration profile ([1:] to [4:]) > [i] > [Edit] > [Camera Access Point]
• You can save up to 4 network configuration profiles in the camcorder. If necessary, touch [Í]/[Î] to scroll
up/down.
3 Enter the SSID (network name) the camcorder will use as a Wi-Fi access point.
[Edit] > Enter the desired network name using the keyboard screen (A 105) > [OK]
• The network name is needed to connect the network device to the camcorder. If necessary, write it down.
4 Touch [5 GHz] or [2.4 GHz] to select the frequency band for the Wi-Fi connection.
Í Î
5 Touch [ ] or [ ] to select the desired channel and then touch [OK].
• Available channels will differ depending on the selected frequency band.
6 Touch [Open/No encryption] or [WPA2-PSK/AES] to select the encryption method.
• If you selected [Open/No encryption], skip to step 8.
7 Enter the encryption key (password).
[Edit] > Enter the desired password using the keyboard screen (A 105) > [OK]
• This password is needed to connect the network device to the camcorder. If necessary, write it down.
8 Continue with the following procedure to configure the IP address assignment (A 106).
Using the virtual keyboard screen
..
1 Touch the keys on the screen to enter the desired text.
• Touch [Ï]/[Ð] to change the position of the cursor.
• Touch [123] to switch between letters and numbers/special
characters.
• Touch [›] to delete the character to the cursor's left.
• Touch [A/a] for caps lock. When the numerical keyboard is
displayed, [#%?] switches between set 1 and set 2 of special
characters.
• When entering passwords and other sensitive information, the character entered will change to a "Ü"
after a moment to protect the information.
2 After entering the desired text, touch [OK].
Connecting to a Wi-Fi Network
Current character / Character limit
105