Sony WX-GS920BH Operating Instructions Manual page 33

CHECK TUNER
 The radio is having difficulty communicating with
the SiriusXM Connect Vehicle Tuner.
 The tuner may be disconnected or damaged.
 Verify that the SiriusXM Connect Vehicle Tuner
cable is securely connected to the radio.
INCORRECT PASS CODE ENTERED
 The entered passcode is incorrect.
 Enter the correct passcode.
 If you forget your passcode, perform "SXM
RESET" in "GENERAL" (page 20).
Note that performing "SXM RESET" will initialize
all the SiriusXM settings and stored contents in
the SiriusXM Connect Vehicle Tuner.
NO SIGNAL
 SiriusXM Connect Vehicle Tuner is having
difficulty receiving the SiriusXM satellite signal.
 Verify that your vehicle is outdoors with a clear
view of the sky.
 Verify that the SiriusXM magnetic mount
antenna is mounted on a metal surface on the
outside of the vehicle.
 Move the SiriusXM antenna away from any
obstructions.
 Inspect the antenna cable for damage and
kinks.
 Consult the SiriusXM Connect Vehicle Tuner
installation manual for more information on
antenna installation.
 Replace the antenna if the cable is damaged.
SiriusXM products are available at your local car
audio retailer or online at
www.shop.siriusxm.com
SUBSCRIP UPDATED - PRESS ENTER TO CONTINUE
 The radio has detected a change in your SiriusXM
subscription status.
 Press ENTER to clear the message.
If you have questions about your subscription,
please contact SiriusXM.
In the USA, visit www.siriusxm.com or call
1-866-635-2349.
In Canada, visit www.siriusxm.ca or call
1-877-438-9677.
For steering wheel remote control
operation:
ERROR: An error occurred during the function
registration.
 Register again from the function where the error
occurred (page 20).
TIMEOUT: The function registration failed due to a
timeout.
 Try completing the registration while [REGISTER]
is blinking (about 6 seconds) (page 20).
For firmware update operation:
ERROR: The updater is not stored in the USB
device.
 Store the updater in the USB device, then try
again (page 23).
NO DEVICE: The USB device containing the updater
is not connected or recognized.
 Make sure the USB device is securely connected.
 Disconnect the USB device, then connect the
device again.
UPDATE ERROR PRESS ENTER: Firmware update is
not completed properly.
 Press ENTER to clear the message, then try again.
During the update, do not turn the ignition to the
OFF position, nor remove the USB device
(page 23).
If these solutions do not help improve the situation,
consult your nearest Sony dealer.
If you take the unit to be repaired because of CD
playback trouble, bring the disc that was used at
the time the problem began.
33
GB