Information On The Display; Help With The Appliance - Siemens wt47w590gb Installation And Operation Instructions Manual

Table of Contents

Advertisement

Y

Information on the display

I n f o r m a t i o n o n t h e d i s p l a y .
Faults
ð on the display and
drying has stopped.
¥ on the display.
é on the display.
The display goes out and
Start/Pause Ü flashes.
* Depending on how the appliance is equipped or the available accessory
--------
If you cannot rectify the fault yourself by turning the appliance off and then on
Note: .
again, please contact our after-sales service.~ Page 47
3

Help with the appliance

H e l p w i t h t h e a p p l i a n c e .
Faults
Appliance does not start.
Creasing.
Water is leaking out.
Programme duration dis-
played changes as dry-
ing progresses.
Cause/remedy
Empty the condensation container and reinsert it.~ Page 30
Press Start/Pause Ü.
Once you have installed the optional drain hose*, make sure that it:
Is correctly connected ~ Page 36
Is free of kinks
Is not blocked or clogged, e.g. with deposits
Remove the fluff.~ Page 31
Press Start/Pause Ü.
Not a fault. The heat exchanger is being cleaned automatically. Do not pull out
the condensation container while this is displayed.
Not a fault. Energy saving mode is active .
Cause/remedy
Check the mains plug and fuse.
Check whether a programme has been selected.
Check that the appliance door is closed.
Check whether the childproof lock is activated. If it is, deactivate the child-
proof lock.~ Page 16
Check whether a "Ready in" time has been selected. If it has, this will delay
the start of a selected programme.
Load exceeded or incorrect programme selected for a type of fabric. All the
required information can be found in the programme table.~ Page 22
Remove laundry from the drum as soon as the drying programme has fin-
ished. Creasing occurs when clothing is left in the drum.
The appliance may be positioned at an angle. Level the appliance.~ Page 13
Not a fault. The moisture sensor measures the residual moisture in the laundry
and adjusts the programme duration (with the exception of timed programmes).
Information on the display
en
41

Advertisement

Table of Contents
loading

Table of Contents