Replacing The Fuses; Replacing The Headlight Bulb - Yamaha 2006 Virago XV250V Owner's Manual

Replacing the fuses

1. Main fuse
2. Signaling system fuse
The main fuse and the signaling sys-
tem fuse holders are located under the
rider seat. (See page 3-8.)
If a fuse is blown, replace it as follows.
1. Turn the key to "OFF" and turn off
the electrical circuit in question.
2. Remove the blown fuse, and then
install a new fuse of the specified
amperage.
Specified fuses:
Main fuse:
20.0 A
Signaling system fuse:
10.0 A
PERIODIC MAINTENANCE AND MINOR REPAIR
EAU23600
CAUTION:
Do not use a fuse of a higher amper-
age rating than recommended to
avoid causing extensive damage to
the electrical system and possibly a
fire.
3. Turn the key to "ON" and turn on
the electrical circuit in question to
check if the device operates.
4. If the fuse immediately blows
again, have a Yamaha dealer
check the electrical system.
ECA10640

Replacing the headlight bulb

This model is equipped with a quartz
bulb headlight. If the headlight bulb
burns out, replace it as follows.
1. Remove the headlight unit by re-
1. Screw
2. Disconnect the headlight coupler,
6-28
moving the screws.
and then remove the bulb cover.
EAU23780
6