Troubleshooting - Beko WMB 81241LS User Manual

5

Troubleshooting

Problem
Program does not start after
closing the door.
Programme cannot be
started or selected.
Water inside the product.
The product does not take
water in.
The product does not drain
water.
Product vibrates or makes
noise.
There is water leaking from
the bottom of the product.
Product stopped shortly
after the programme
started.
Product directly discharges
the water it takes in.
No water can be seen in the
product during washing.
Loading door cannot be
opened.
41 / EN
Reason
Start / Pause / Cancel button was not pressed.
The product may have switched to self protection
mode due to a supply problem (line voltage, water
pressure, etc.).
Some water might have remained in the product
due to the quality control processes in the
production.
Tap is turned off.
Water inlet hose is bent.
Water inlet filter is clogged.
Loading door may be open.
Water drain hose might be clogged or twisted.
Pump filter is clogged.
Product might be standing unbalanced.
A hard substance might have entered into the
pump filter.
Transportation safety bolts are not removed.
Laundry quantity in the product might be too little.
Excessive laundry might be loaded in the product.
Product might be leaning on a rigid item.
Water drain hose might be clogged or twisted.
Pump filter is clogged.
Machine might have stopped temporarily due to
low voltage.
Draining hose might not be at adequate height.
Water is inside the invisible part of the product.
The cover lock is activated due to the water level
inside the product.
Product is heating up the water or it is at the
spinning cycle.
Child lock is engaged. Door lock will be deactivated
a couple of minutes after the programme has
come to an end.
Solution
• *Press the Start / Pause / Cancel
button.
• Press and hold Start / Pause / Cancel
button for 3 seconds to reset the
product to factory settings. (See.
Cancelling the programme")
• This is not a failure; water is not
harmful to the product.
• Turn on the taps.
• Flatten the hose.
• Clean the filter.
• Close the door.
• Clean or flatten the hose.
• Clean the pump filter.
• Stable the product by adjusting the
feet.
• Clean the pump filter.
• Remove the transportation safety
bolts.
• Add more laundry to the product.
• Take out some of the laundry from
the product or distribute the load by
hand to balance it homogenously in
the product.
• Make sure that the product is not
leaning on anything.
• Clean or flatten the hose.
• Clean the pump filter.
• Product will resume running when the
voltage restores to the normal level.
• Connect the water draining hose as
described in the operation manual.
• This is not a failure.
• Drain the water by running the Pump
or Spin programme.
• Wait until the programme completes.
• Wait for a couple of minutes for
deactivation of the door lock.
Washing Machine / User's Manual