Diagrams - Sony CX-LEM550 Service Manual

THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed in each block.)
For Schematic Diagrams.
Note:
• All capacitors are in µF unless otherwise noted. (p: pF).
50 WV or less are not indicated except for electrolytics and
tantalums.
• All resistors are in Ω and
1 / W or less unless otherwise
4
specified.
• f : internal component.
• 5 : fusible resistor.
• C : panel designation.
Note: The components identified by mark 0 or dotted
line with mark 0 are critical for safety.
Replace only with part number specified.
• A : B+ Line.
• B : B– Line.
• H : adjustment for repair.
• Voltages and waveforms are dc with respect to ground un-
der no-signal (detuned) conditions.
no mark: TUNER (FM)
( ): CD PLAY
〈 〉 : TAPE REC
• Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal production
tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal production
tolerances.
• Circled numbers refer to waveforms.
• Signal path.
F
: TUNER (FM/AM)
J
: CD PLAY
E : TAPE PLAY
a : TAPE REC
j
: MD (AUX) IN
• Abbreviation
E51 : Chilean and peruvian models
KR : Korea model
SP : Singapore model
SECTION 7

DIAGRAMS

For Printed Wiring Boards.
Note:
• X : parts extracted from the component side.
• Y : parts extracted from the conductor side.
W : indicates side identified with part number.
•
• f : internal component.
• : Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
Caution:
Pattern face side : Parts on the pattern face side seen from
(Conductor side) the pattern face are indicated.
Parts face side : Parts on the parts face side seen from
(Component side) the parts face are indicated.
• Indication of transistor.
C
Q These are omitted.
B E
Q
B C E
These are omitted.
Q
B C E
These are omitted.
• Circuit Boards Location
CONTROL board
HP board
15 15
MAIN board
CD board
POWER board
TUNER unit
CX-LEM550
AMP board