Wireless Client Mode - D-Link DAP-1155 User Manual

Section 3 - Configuration
Wireless Mode:
Select Wireless.Client.Mode from the drop-down menu.
Site Survey:
Wireless Type:
Click Site.Survey to display a list of wireless networks in your area. You
may select the wireless access point to connect to.
Select Infrastructure if connecting to an access point or wireless router,
or select Ad-Hoc if connecting to another wireless client.
Wireless Network
Enter the SSID of the access point you want to repeat the signal of. If
Name:
you do not know for sure, click Site.Survey and select it from the list,
if available.
802.11 Mode:
Select the appropriate 802.11 mode based on the wireless clients in
your network. The drop-down menu options are 802.11n.Only,.Mixed.
802.11n.and.802.11g,.or.Mixed.802.11n,.802.11g.and.802.11b.
Wireless Channel:
The channel will automatically change to the channel of the AP you
are connected to.
Enable Auto
The Auto.Channel.Scan setting can be selected to allow the DAP-1155
Channel Scan:
to choose the channel with the least amount of interference.
Channel Width: Select the appropriate channel width between 20MHz or Auto.
20/40MHz from the drop-down menu.
Visibility Status:
Check the box if you do not want the SSID to be broadcast by the DAP-
1155. This prevents the SSID from being seen by site survey utilities, so any wireless clients will have to be pre-configured with the
SSID of the DAP-1155 in order to connect to it.
Wireless MAC You can clone the wireless MAC address to connect the device.
Clone:
Select a wireless security setting. Options are None, WEP, WPA, or WPA2. See the Wireless Security section in this manual for a detailed
Wireless Security
Mode: explanation of the wireless security options.
Select enable if you want to configure the DAP-1155 with Wi-Fi Protection setup.
WPS:
D-Link DAP-1155 User Manual

Wireless Client Mode

24