Toshiba SD-270EKB Owner's Manual page 8

System or AV Receiver to hear better sound, scart is
enough for both audio and video connections.
Using Component Video Jacks(Y PB PR)
IMPORTANT!
-The progressive scan video quality is only pos-
sible when using Y PB PR and a progressive scan
TV is required.
A Use the component video cables (red/blue/green) to
connect the DVD player' s Y P
responding Component video input jacks (or labelled
as Y P P ) on the TV (cable not supplied).
b r
B Use the audio cables (white/red) to connect AUDIO
OUT (L/R) jacks of the DVD player to the correspond-
ing AUDIO IN jacks on the TV (cable not supplied).
C Proceed to page 11 for detailed Progressive Scan set
up.
Using a RF modulator
IMPORTANT!
－If your TV only has a single Antenna In jack (or
labelled as 75 ohm or RF In), you will need a RF
modulator in order to view the DVD playback on
the TV.
Helpful hint: before making or changing any connections, make sure that all the devices are
disconnected from the power outlet.
P jacks to the Cor-
B R
Connections
A Use the composite video cable (yellow) to connect the
DVD player' s CVBS jack to the video input jack on the
RF modulator (cable supplied).
To hear sound of this DVD player through your
TV, use the audio cables(white/red) to connect
AUDIO OUT (L/R) jacks of the DVD player to the
corresponding AUDIO IN jacks on the RF modulator
(cable supplied).
B Use the RF coaxial cable (not supplied) to connect
ANTENNA OUT or TO TV jack on the RF modulator to
the ANTENNA IN jack on the television.
C Connect the Antenna or Cable TV service signal to
the ANTENNA IN or RF IN jack on the RF modulator.
(It may have been connected to your TV previously.
Disconnect it from the TV.)
(continued)