Panasonic TH-P42X30A Operating Instructions Manual page 23

R-Gain
G-Gain
B-Gain
R-Cutoff
G-Cutoff
B-Cutoff
Reset White
Balance
Gamma
• S Curve /
1.8 / 2.0 / 2.2
/ 2.4 / 2.6
Reset Gamma
Refresh Rate
• 50 Hz
• 100 Hz
Side Panel
• Off
• Low
• Mid
• High
16:9 Overscan
• Off
• On
DVI Input Setting
• Normal
• Full
Pixel Orbiter
• Auto
• On
Scrolling Bar
Reset Picture Defaults
∗ 1 : PC input mode only
Adjusts the white balance of bright red area
Adjusts the white balance of bright green area
Adjusts the white balance of bright blue area
Adjusts the white balance of dark red area
Adjusts the white balance of dark green area
Adjusts the white balance of dark blue area
Press the OK button to reset to the default White Balance
Switches the gamma curve
•
Please note the numerical values are reference for the adjustment.
Press the OK button to reset to the default Gamma
Changes the image processing of the panel (depending on the input
signal)
•
Set to [100Hz] normally
Increases the brightness of the side panel
•
The recommended setting is [High] to prevent panel "image retention".
[On] : Default - Image is overscanned by ~5% beyond the edge of the
screen to hide edge video noise
[Off] : Displays image in its original size including edge video noise such
as lines, dashes, dots etc.
•
Applicable for video signals when TV aspect is set to [16:9]
•
Memorised separately for SD and HD channels / signals
Changes the black level in the image for HDMI input mode with DVI input
signal manually
•
When the DVI input signal from the external equipment, especially from PC,
is displayed, the black level may not be suitable. In this case, select [Full].
•
The black level for HDMI input signal will be adjusted automatically.
•
For HDMI input mode with DVI input signal only.
Selects the mode for wobbling of the image to prevent panel "image
retention"
[Auto]: Automatically works only for the appropriate images and you
rarely recognise the wobbling.
Scrolls the vertical bar to prevent panel "image retention"
•
Press the OK button to start scrolling and press any buttons (except
Standby) to exit this mode.
Press the OK button to reset settings of Picture Viewing Mode to the
default.
23