Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Beko DC 1560
Summary of Contents for Beko DC 1560
- Page 1 Dryer DC 1560...
-
Page 2: Explanation Of Symbols
Read this manual prior to initial operation of the product! Dear Customer, We hope that your product, which has been manufactured in modern facilities and passed through a strict quality control procedure, will give you very good results. We advise you to read through this manual carefully before using your product and keep it for future reference. -
Page 3: Important Safety Information
Important safety information This section includes safety information that will fuel oil, dry-laundry solvents and other help protection from risks of personal injuries combustible or explosive materials as or materialistic damages. Failure to follow well as the items that are contaminated these instructions shall cause any warranty and or spotted with such materials should not reliability commitment to become void. -
Page 4: Intended Use
• Do not reach into the machine when the are attended by a person who will be drum is spinning. responsible for their safety or who will • Unplug the machine when it is not in use. instruct them accordingly for use of the •... -
Page 5: Appropriate Installation Location
Installation reach 180 kg when they are full. Therefore, Refer to the nearest Authorised Service Agent the floor must be capable of carrying the for installation of your product. load on it! Preparation of location and electrical Ventilation hose and connection installation for the product is under (for products equipped with an customer’s responsibility. -
Page 6: Adjusting Feet
fireplace. Do not operate your product at the same time with heaters such as a coal or gas stove. Airflow may cause the chimney to flare up. Connection to water drain (Products with a condenser); In products equipped with condenser unit, water accumulated during the drying cycle accumulates in the water tank. -
Page 7: Electrical Connection
First use wet and slippery surfaces. To install the plastic parts: • To have the product ready for operation 1. Tilt your product to backwards. before calling the authorised service agent, 2. Fit the plastic parts on to the front make sure that its location and power adjustable feet. -
Page 8: Initial Preparations For Drying
Initial preparations for drying Things to be done for energy saving: A B C • Make sure that you operate the product at its full capacity but pay attention to not exceeding it. • Spin your laundry at the highest speed possible when washing them. - Page 9 A Consider the information in the not be dried in the product since they emit flammable or explosive vapor. "Programme Selection Table". Always • Do not dry items cleaned with industrial start the programme in accordance chemicals in the dryer. with the maximum load capacity.
-
Page 10: Control Panel
Selecting a Program and Operating Your Machine Control panel 1. Filter cleaning warning light 6. Start/Pause/Cancel button Warning light turns on when the filter is full. Used to start, pause or cancel the 2. Program follow-up indicator programme. Used to follow-up the progress of the 7. -
Page 11: Preparing The Machine
Preparing the machine laundry from creasing will be activated if you do not take the laundry out after the program 1. Plug in your machine. has come to an end. This program rotates 2. Place the laundry in the machine. the laundry in 10 minutes intervals to prevent 3. -
Page 12: Program Selection And Consumption Table
Program selection and consumption table Program table Approximate Capacity Spin speed in washing amount of Drying time Programs (kg) machine (rpm) remaining (minutes) humidity Cottons / Coloreds 1200-1000 % 60 900-800 % 70 Ready to Wear 1200-1000 % 60 80-60 900-800 % 70 100-80... -
Page 13: Auxiliary Function
Auxiliary function Changing the program after the Buzzer Cancel Models Equiped program has started Your machine will send out an buzzer warning You can use this feature to dry your clothes when the program comes to an end. If you under higher or lower temperatures after your do not want to hear this buzzing, you need to dryer has started. -
Page 14: Childproof Lock
process, but this process will extend the 3 seconds. The “Filter cleaning”, “Water tank” programme duration and increase energy and “End/ Anti-creasing” warning lights will consumption since the drying will be turn on at the end of this period for reminding interrupted continuously. -
Page 15: Maintenance And Cleaning
Maintenance and cleaning Cover filter since these materials can cause fire and explosion! Lint and fibres released from the laundry to the Water tank (Products equipped with a air during the drying cycle are collected in the “Cover Filter”. condenser); The moisture in the damp laundry is taken from the laundry and condensed. - Page 16 4. Clean the condenser with pressurized water and wait until the water drains. 5. Replace the condenser with the side of it labelled with “Top” facing upwards. Lock the 4 condenser locks. Make sure that the red lock on the upper right corner is engaged securely.
-
Page 17: Solution Suggestions For Problems
Solution suggestions for problems Drying process takes too much time • Meshes of the filter may be clogged. Wash with water. Laundry come out wet at the end of drying. • Meshes of the filter may be clogged. Wash with water. •...