Kenwood DNN9150BT Quick Start Manual page 24

Ñ Connecting wires to terminals
Ignition key
switch
Car fuse box
(Main fuse)
Battery
To use the steering wheel remote control
feature, you need an exclusive remote adapter
(not supplied) matched to your car.
To car light control switch
Connect to the terminal that is grounded
when either the telephone rings or during
To use the Mute feature, you need to hook
up this wire to your telephone by using a
commercial telephone accessory.
Depending on what antenna you are using,
connect either to the control terminal of the
motor antenna, or to the power terminal for the
of the film-type antenna. (Max. 300mA, 12V)
When using the optional power amplifier,
connect to its power control terminal.
24
ñ English
HDMI/MHL
MIC
AV-OUT
AUDIO
ACC
Red (Ignition wire)
Yellow (Battery wire)
Car fuse box
Black (Ground wire) ¤
(To car chassis)
A
A
Light Blue/Yellow
(Steering remote control wire)
To steering remote
conversation.
booster amplifier
M4 x 8mmMAX
GPS
iPod/
AV-IN/OUT
AV-IN2
R L
Accessory 1
REMOTE STEERING
CONT WHEEL
REMOTE
INPUT
Orange/White (Dimmer
control wire)
ILLUMI
Brown (Mute control wire)
MUTE
Blue
(Antenna control wire)
ANT CONT
Blue/White
(Power control wire)
P. CONT
If no connections are made,
do not let the cable come out from the tab.
REMO
TE
POWER
Speaker impedance: 4-8 Ω
White/Black
+
White
Gray/Black
+
Gray
Green/Black
+
Green
Purple/Black
+
Purple
To front left
speaker
To front right
speaker
To rear left
speaker
To rear right
speaker