Connections; Audio Out Terminals Connection - Panasonic TH-103PF12W Operating Instructions Manual

Connections

AUDIO OUT Terminals connection

– AC cord fi xing
Plug the AC cord into the display unit.
1
Plug the AC cord until it clicks.
2
Fix the AC cord with the clamper.
Note:
Make sure that the AC cord is locked on both the left and right sides.
– Cable fi xing band
Secure any excess cables with band as required.
Note:
Two fi xing bands are supplied with this unit. In case of securing cables at four positions, please purchase it separately.
Pass the attached cable
fi xing band through the clip
as shown in the fi gure.
1
SLOT1
Optional Dual HDMI Terminals
(equivalent of Dual
Terminal
HDMI Terminal Board
Board Insert
(TY-FB10HMD))
Slot (covered)
(see page 13)
Note: Terminal board is installed in SLOT 2 and SLOT 3 at factory shipment.
10
AC cord connection (see page 14)
To secure cables connected to Terminals, wrap the cable fi xing band around them
then pass the pointed end through the locking block, as shown in the fi gure.
While ensuring there is suffi cient slack in cables to minimize stress (especially
in the power cord), fi rmly bind all cables with the supplied fi xing band.
2
SLOT2
LAN Terminal
(see page 61)
AUDIO OUT
Close
Push
until
the hook
clicks.
Open
2. Pull
off.
1. Keep the
knob
pressed.
To tighten:
Pull
AUDIO
P /C /R P /C /B Y/G
R R B B
LAN COMPONENT/RGB IN
SLOT3
COMPONENT/ From EXTERNAL
RGB IN monitor terminal
Terminals on Computer
(see page 13) (see page 11)
R L
Stereophonic sound code
audio equipment
line-in
Unplug the AC cord
Note:
When disconnecting the AC cord,
be absolutely sure to disconnect
the AC cord plug at the socket
outlet fi rst.
To loosen:
Push the catch
AUDIO
PC IN SERIAL
From SERIAL
Terminal on
Computer
(see page 12)
Unplug the AC
cord pressing
the two knobs.
Pull
R L
AUDIO OUT
From input
on audio
amplifi er
(see page 10)