Wall Receptacles And Power Cords - HP Latex Plus Site Preparation Manual

Wall receptacles and power cords

Two power cords are provided with your cutter, according to the cutter's electrical specifications. If those cords do
not reach your PDU and/or UPS, a certified electrician must install suitable extension cables on the day of
installation.
To make sure you have the right wall socket outlets (wall receptacles) ready for installation, check the following:
1. The wall socket outlets must be suitable for cutter input ratings. See
2. The wall socket outlets must be suitable for the power cord plug type used in the country of installation.
The tables below give examples of the power cords and the plugs provided with the cutter according to the
country. To make sure you have the right wall receptacle, find your country in the appropriate table and
check the plug type.
WARNING!
(relocatable power tap) to connect both power cords. Do not damage, cut, or repair the power cord. With a
damaged power cord, there is risk of fire and electric shock. Always replace a damaged power cord with an
HP-approved power cord.
Table 2-5 Power cord specifications by country
Country
Argentina
Australia
Brazil
Cambodia, Indonesia, Korea, Vietnam
Chile, Uruguay
6 Chapter 2 Site preparation requirements
Use only use the power cord supplied by HP with the cutter. Do not use a power strip
Length
2.5 m
2.5 m
2.5 m
2.5 m
2.5 m
Single-phase power on page
Plug type
IRAM 2073
AS/NZS 3112:2000
NBR 14136
CEE 7-VII
CEI 23-50
5.
Plug
ENWW