Content Index 1. General Safety Instructions ..................3 1.1 SAFETY: General Safety ..................3 1.2 SAFETY: General Power Safety ................5 2. Exploded view diagram with list of items ..............6 3. Wiring connectivity diagram ..................7 4. Disassembly and Assembly Procedures ..............8 4.1 Disassembly SOP ....................
IMPORTANT NOTICE FOR USE IN HEALTHCARE ENVIRONMENTS: Dell products are not medical devices and are not listed under UL or IEC 60601 (or equivalent). As a result, they must not be used within 6 feet of a patient or in a manner that directly or indirectly contacts a patient 1.1 SAFETY: General Safety...
Page 4
When operating your equipment: Do not use your equipment in a wet environment, for example, near a bath tub, sink, or swimming pool or in a wet basement. Do not use AC powered equipment during an electrical storm. Battery powered devices may be used if all cables have been disconnected.
socket. If your equipment uses an AC adapter: Use only the Dell provided AC adapter approved for use with this device. Use of another AC adapter may cause a fire or explosion. NOTE: Refer to your system rating label for information on the proper adapter model ...
4. Disassembly and Assembly Procedures 4.1 Disassembly SOP Preparation before disassembly 1. Clean the room for disassembly 2. Identify the area for monitor 3. Prepare the equipment, tool and material as bellow: 1) Working table 2) Philips-head screwdriver 3) Hex-head screwdriver 4) Glove 5) Cleaning cloth 6) ESD protection...
Page 9
1. Use a long and thin Philips-head screwdriver to push screwdriver the release latch located in a hole just above the stand. 2. Once the latch is released, remove the base away from the monitor. 3. Press down on the quick release tab latch on the bottom of the base to...
Page 10
1. Remove Control BD FFC cable from I/F 2. Remove backlight wire from SPS BD 1. Remove LVDS cable from panel 2. Take off Main SHD from Panel 1. Disassemble Safety Mylar from Main - 10 -...
Page 11
1. Unlock 5 PCBA 1. Philips- screws and 2 hex head screws screwdriver Torsion of screw: 6.5±1.0Kg 2. Hex-head screwdriver Torsion of hex screw: 5.0±0.6Kg 2. Disassemble SPS BD and I/F BD from Main SHD 3. Remove SPS wire from I/F BD 4.
4.2 Assembly SOP Preparation before assembly 1. Clean the room for disassembly 2. Identify the area for monitor 3. Prepare the equipment, tool and material as bellow: 1) working table 2) Philips-head screwdriver 3) Hex-head screwdriver 4) Glove 5) Cleaning cloth 6) ESD protection Item Picture...
Page 13
1. Assemble Safety Mylar on Main SHD 1. Place Panel on a soft cloth or cushion 2. Place Main SHD on panel and Insert LVDS cable into panel 1. Insert backlight wire into SPS 2. Insert Control BD FFC cable to I/F BD and paste Control BD FFC cable on Main SHD and Panel...
Page 14
1. Assemble the stand column to stand base. 1. Attach the stand assembly to the monitor. 2. Attach the VESA Cover on Rear Cover - 14 -...