Sharp AR-SS2 Service Manual page 16

AR-SS2
[6] DIAGNOSTICS
1. PWB
2. List of DIP switch functions
The functions of the DIP switch (SW1) on the sorter controller PWB
are as follows:
Purpose
Normal copy state
Transport motor (M2)
Sensor adjustment mode (Bin
paper sensor)
Guide for operation range
adjustment mode (When A4
size is used)
Guide bar operation range
adjustment mode (When letter
size is used)
Guide bar operation text
Stapler unit oscillation position
adjustment
∗
1: Do not move No. 6 of DIP switch, which is used only for selection of the communication system with the copier.
(ON: Now IPC communication / OFF: Old IPC communication)
LED SW1 SW2 SW3
DIP switch setup
ON 1
1 2 3 4 5 6
ON 1
1 2 3 4 5 6
ON 1
1 2 3 4 5 6
ON 1
1 2 3 4 5 6
ON 1
1 2 3 4 5 6
ON 1
1 2 3 4 5 6
ON 1
1 2 3 4 5 6
•
When all are set to OFF, the machine returns to the normal mode.
•
When the manual staple key (SW) is pressed, the transport motor (M2)
rotates forward (in the paper transport direction). To stop the motor,
press the manual staple key (SW) again.
•
When the manual staple key (SW) is pressed, adjustment of the bin
paper sensors (S1, S2) is performed. (For details, refer to page 5-1)
Adjustment complete: Manual staple key (SW) ON
Adjustment error: Manual staple key (SW) blinking
In case of an adjustment error, check which sensor is malfunctioning by
the error code.
Error code F1-91: S1, S2 error
•
For details, refer to page 5-1.
•
For details, refer to page 5-1.
•
When the manual staple key (SW) is pressed, the guide bar operates.
The operation of A4R -> B5 -> Letter R -> A4R is repeated. When the
manual staple key is pressed again, the guide bar returns to the home
position.
•
For details, refer to page 5-2.
6 – 1
Content