1 Warning Caution: - Pb free solder has a higher melting point that standard solder Typicall the melting point is 50 - 70°F (30 - 40°C) a higher. Please use soldering iron with temperature control and adjust it to 750 ± 20°F (400 ± 10°C). In case of using high temperature soldering iron, please be careful not to heat too long.
4 Disassembly and Assembly Instructions 4.1. Disassembly instruction 1. Remove Shaft Cover from Main Body by Slotted screw 4. Remove Pivot spring by gripping and pulling it out from driver (Minus Driver.) the Main body. 2. Remove Torx screws at Shaft position by Phillips screw driver (Plus driver).
Page 6
7. Remove Lock Button and Lock Button Spring. 10. Take off Press Plate. 8. Remove Iron Plate of Heater B from Hook. 11. Remove 2 screws of the Housing side by Phllips screw driver (Plus Driver). 9. Remove Slide Plate and Slide Spring. 12.
Page 7
13. Remove Housing A from Housing B in Grip follow as 14. Take off Iron Plate and Circuit assembly b/k from Housing below drawing.
4.3. Lead wire of Iron Plate (Heater A , Heater B) and Circuit arrangement points. 1. Lead wire of Iron Plate (Heater A assembly b/k) and Circuit assembly b/k arrangement follow as below. 2. Lead wire of Iron Plate(Heater B assembly b/k) arrangement follow as below. 3.