AEG IMS 4441 iP Instruction Manual page 28

English
28
6 (open/close) CD compartment
7 Indicator
8 I/ Button (standby/power)
9 Speaker
10 CD compartment
11 LCD display
12 SNOOZE button
13 AUX IN connection
14 headphone jack
Rear view (not shown)
DC 12 V power supply socket
FM ANT. aerial antenna
Remote control
1 FUNC Function selector
2 SLEEP button
3 / AUT� MEM button (Play/Pause / automatic station
search)
4 / ST/MONO button (Stop / Stereo/Mono)
5 MEM/CLK-ADJ / SN��ZE button (Memory/time)
6 ALARM button
7 PRESET EQ button (Equalizer)
8 V�LUME +/- button s
9 PLAY M�DE / i-REPEAT button (play mode)
10 ID3/DISPLAY / i-SHUFFLE button
11 / F�LDER/PRE / i-MENU/i-ENTER buttons
12 -10/+10 / i-SCR�LL / buttons
13 / / TUNING/SKIP / buttons
14 I/ button (Standby/On)
Installation/Introduction
• Read the manual thoroughly before operating the de-
vice!
• Choose a suitable location for the device. Suitable loca-
tions are dry, even and anti-slip surfaces on which you
may operate the device easily.
• Make sure there is proper ventilation for the device!
• Remove, if necessary, the protection sheet from the
display.
NOTE:
• The unit is mainly operated via the remote control. The
description of the buttons therefore refers to the re-
mote control. Some buttons can also be found on the
unit. Buttons with the same name perform the same
function.
• If the remote control is in the storage compartment (4
on the unit), you can continue to operate the unit via
the remote control. The signals are forwarded to the
unit via an IR sensor (3).
Power supply
• Plug the power supply into a properly installed 230 V,
50 Hz earthed socket.
• Connect the unit to the power supply by plugging the
power supply jack into the DC 12 V connector on the
back of the unit.
• Make sure the voltage is in conformity with the rating
plate.
• The time and station settings will be lost as soon as the
power supply is interrupted.
CAUTION:
• The supplied power supply may only be used with this
unit. Do not use it for other units.
• �nly use a 12 V (
power supply may damage the unit.
NOTE:
If the unit is out of use for long periods, disconnect the
power supply from the mains.
Insert/Replace Battery in Remote Control
NOTE:
Where necessary, the lithium cell in the battery compart-
ment of the remote has been fitted with a protective foil for
transport. This extends the lifetime of the battery. Before
initial use please remove this foil to prepare the remote for
use.
The battery in the remote is a long-life lithium cell. Should
the range of the remote shorten during use, follow the steps
below:
• �pen the battery compartment on the underside of the
remote.
• Replace the cell with a battery of the same type
(CR 2032). Make sure the polarity is correct.
• Close the battery compartment.
If the remote is not in use for a lengthy period of time, please
remove the battery to prevent the battery acid from "leaking".
WARNING:
• Do not expose batteries to intense heat or direct
sunlight. Never throw batteries onto a fire. Danger of
explosion!
• Keep batteries out of the reach of children. They are
not toys.
• Do not force batteries open.
• Avoid contact with metallic objects. (Rings, nails, screws
etc.) Danger of short circuits!
• Short circuits may overheat or even ignite batteries.
This may lead to combustion.
• When transporting the batteries, cover the terminals
for your safety with an adhesive strip.
) power supply. A different