Husqvarna 524LK Operator's Manual page 14

2. Clean the area around the fuel tank cap.
3. Remove the fuel tank cap slowly to release the
pressure.
4. Fill the fuel tank.
CAUTION:
not too much fuel in the fuel tank. The
fuel expands when it becomes hot.
5. Tighten the fuel tank cap carefully.
6. Clean fuel spillage on and around the product.
7. Move the product 3 m/10 ft or more away from the
refueling area and fuel source before you start the
engine.
Note:
To see where the fuel tank is on your product,
Product overview on page 3 .
refer to
To start the product
1. Move the stop switch to the start position.
2. Set the choke control to the choke position.
14
Make sure that there is
3. Push the air purge bulb until fuel starts to fill the air
purge bulb.
4. Hold the product to the ground.
5. Pull the starter rope handle slowly with your right
hand until you feel resistance.
WARNING:
rope around your hand.
CAUTION:
rope to full extension and do not let go of
the starter rope handle. This can cause
damage to the product.
6. Pull the starter rope handle quickly and with force
until the engine starts.
7. Set the choke control to the operation position.
WARNING:
from the spark plug cap. Risk of burn
injuries. Do not use the product with a
damaged spark plug cap. Risk of
electrical shock.
Do not wind the starter
Do not pull the starter
Keep body parts away
1309 - 004 - 23.03.2021