Advertisement
1
4
PE N L
INSTALLATION
Step 1: Unfasten the front screw and remove the cover. Next, unfasten the four retaining screws without
removing them and remove the diffusor.
Step 2: Install the supplied cable gasket from the inside of the plastic base.
Step 3: Use a drill with a 3,5mm bit to open the 4 mounting holes located in the plastic base. Place the
luminaire on the desired mounting location and mark and drill these 4 holes. Fit the supplied 4
plastic mounting plugs to these drilled holes on the mounting location.
Step 4: Open a cable entry cutout hole on the plastic base and install the supplied cable gasket. Make a
hole in the center into the desired gasket by using a small screwdriver and pass the round cable
through the gasket. Connect the main cables to the respective terminal block: N for neutral, L for
live wire and PE for ground wire. Install the included tie (if needed) to fasten securely the power
cables. Always use in any case round mains cable, with a diameter of 5-10mm (H05RN-F type
2x1mm² or any other type, at least equal to it's mechanical and electrical properties). ATTENTION!!
The cable must not be deformed in any way (This requirement is important to ensure the IP rating).
Step 5: Mount the base to the desired location by using the supplied screws, washers and o-rings in
each mounting hole.
Step 6: Re-install the diffusor, fasten the four retaining screws, refit the cover and fasten the screw that
was removed in step 1.
The light source contained in this luminary shall only be replaced by the manufacturer, or his
agent, or a similar qualified person.
NOTE! The light source is non-user replaceable.
At the end of their useful life the packaging and product
should be disposed of via a suitable recycling centre.
Do not dispose of with your normal household waste.
Do not burn.
Honeywell Life Safety AS, Po. Box 3514, N-3007 Drammen, Norway
MOUNTING METHODS
Surface mounting on the wall
2
PE N L
5
PE N L
3
washer
6
rubber
o-ring
http://www.hls-nordic.com
GB
PE N L
Advertisement
