Canon PIXMA MX350 Network Setup Manual page 13

6
Select Directly enter the access point name, then
press the OK button.
• If you are living in an apartment, nearby access points in
use may be detected.
7
Enter the access point name/network name (SSID)
using the Numeric buttons, then press the OK button.
For details on how to enter characters, refer to "Character
Entry" on page 10.
• Enter the same access point name/network name (SSID)
as that of the access point on the machine.
• For details on how to check the access point name/network name (SSID), refer to the
manual supplied with the access point or contact its manufacturer.
• Enter upper and lower case letters of the alphabet correctly. Letters are case sensitive.
8
Make sure that the access point name/network name
(SSID) is correct, then press the OK button.
9
Select a security protocol for the access point, then
press the OK button.
• Go to either of the following steps according to the selected
security protocol.
Go to
Disable
13.
Go to
WEP
Go to
WPA/WPA2
page 13.
• When WEP 40 bit or WEP 128 bit is selected in AirPort Utility (AirPort Admin Utility), select
WEP.
• When WEP (Transitional Security Network) is selected in AirPort Utility, select WPA2-PSK
(AES).

on page
.
on
10-A
WEP
1
Select the WEP key number you want to use,
then press the OK button.
• When using AirPort, select WEP key 1 in the
screen. Selecting other key numbers will disable
the connection between the machine and AirPort.
2
Enter the network key, then press the OK
button.
• Enter upper and lower case letters of the alphabet
correctly. Letters are case sensitive.
3
Make sure that the network key is correct, then
press the OK button.
Go to on page 13.
WPA/WPA2
(P.13)
Disable
(P.13)