Advertisement
Set-Up/Debug Commands
Debug=<0-4>
Debug?
This sets the amount of debug info sent to dvDebug.
Debug:dvDebug=<D:P:S>
Debug:dvDebug?
By default, we send debug messages to 0:1:0 so they show up in the telnet window when you type msg
on. If you prefer, you can send them to a virtual device to log them or to relay messages from multiple
masters to a single one so they are displayed in one place.
Debug:Name=<UniqueName>
Debug:Name?
Debug strings from the module will usually come up as YamahaMTX5D(D:P:S) where D:P:S is replaced
with the vdvCom address of this module. If you want to use a different name for debug purposes, you can
assign a new name with this command. You can shorten the name or create more distinct names when
multiple MTX5-D units are present such as MTX5D-MtgRms or MTX5D-BallRms.
Set:IP=<IP Address>:49280:IP_TCP
Set:RS232=Delay=<1/10 sec>:HSOFF:XOFF:SET BAUD <38400|115200>,N,8,1 485 DISABLE
Sets parameters for the module to connect to the MTX5-D.
For IP, you will want to send in the IP address and other IP settings as shown, then turn on channel 250
on vdvCom. Whenever channel 250 is on, the module tries to keep the IP socket connected. (If the
connection is lost, the module will automatically attempt to re-establish the link.) If the channel is off, the
module will disconnect and wait for the module to re-link.
For RS232, you effectively send the serial port initialization strings. In older processors, sometimes the init
strings needed to be delayed from the online event. You can type in an appropriate delay in this module
and it will take care of it for you.
Init=<0|1>
This command launches a routine to sends the control port "WakeUp" string and scans the current status of
all tracked status. The routine uses a timeline to churn through all initial status and takes several minutes
to complete. Sending a value of 1 cancels an existing routine and starts over. Sending a value of 0
terminates a routine in progress.
Passthru=<STRING TO SEND>
Anything after the equal sign is sent to the serial port. A Line Feed is added at the end for you.
AMX Control Module for: MTX5-D Matrix Processor Rev.1
Debug Values
0
No Debug Messages
1
Errors Only
2
Show API Exchanges
3
Show Raw Protocol Values
4
Show Parsing Process Messages
6
Advertisement
