Canon Lunar Globe Assembly Instructions

Lunar Globe : Assembly Instructions
Assembling the main body of the lunar globe
1.
Cut out the front side of
the Moon (upper half)
and the back side of
the Moon (upper half)
and glue them together
using the central tabs.
* This model was designed for Papercraft and may differ from the original in some respects.
Assembly Instructions : Three A4 sheets (No. 1 to No. 3)
* Build the model by carefully reading the Assembly Instructions, in the parts sheet page order.
2.
Cut out the upper half base. Use scissors to
cut out the center hole. Cut out the center by
first cutting with scissors along the red line
connecting the center to the exterior.
After cutting out the hole,
glue the reinforcement to
the reverse side, taking
care to ensure it doesn't
obstruct the fold lines.
name
3.
1
Glue the back side of the Moon (upper half) to
the upper half base by attaching the red circles
on the back side of the Moon (upper half) into
place on the glue tabs near the joints of the
upper half base, as shown in the illustration.
Attach the red cir-
cles into place at
these positions.