Toro Power Max 107-3827 Installation Instructions Manual page 2

5. Secure the bracket to the right side of the handle using
the U-clamp, 2 washers, and 2 locknuts (1/4 in.)
provided in the kit (Fig. 3).
4
5
Figure 3
1. Headlamp
2. Bracket
3. Nut (5/16 In.)
4. Wire harness
6. Secure the headlamp onto the bracket (Fig. 3) with the
nut (5/16 in.) provided in the kit.
7. Insert the wire connector (with the plastic clip on the
bottom) straight into the back of the headlamp until it
is securely in place (Fig. 3).
8. Secure the wire harness to the upper right side of the
handle assembly with a plastic cable tie (provided in
the kit) about an inch (2.5 cm) below the U-bolt
(Fig. 3).
Important Ensure that you do not pinch the wire
harness when you install it.
1
2
3
8
6
7
5. Handle
6. U-bolt
7. Plastic cable tie
8. Locknuts (1/4 in.)
2