Download Print this page

Electrolux TRMKTEZ2FL75 Instruction Sheet page 11

Single-door all refrigerator and all freezer trim kit

Advertisement

Power and Water Line Connection
Note: Refer to the Use & Care Manual for power requirements and water
supply hookup before proceeding. Find Service Kit TTFLTRICEKIT at
ElectroluxAppliances.com for connecting the water line and filtering ice.
Top Trim Attachment
NOTE
You will need a step ladder to install top trim components.
Note: If freezer unit is compatible with water filter kit, please see filtered
water kit instructions.
22. a.
Remove the front outer
hinge screws, common
on both sides of the
dual installation, as well
as the front two 4H
screws that fasten the 1H
Tie Bar (Fig. 21).
b.
Roll the dual installation
into the cabinet, roughly
¾ of the way in, ensuring
the product is centered
in the cabinet cutout.
c.
Install the top trim by
fastening four 4H screws
along the base of the
/
"
5
trim with a
socket
16
wrench (Fig. 21).
23. a.
Slide the dual installation
into place, and make
sure it is center inside
the cabinets.
/
"
1
b.
Drill
pilot holes and
8
fasten two 3H screws
on the right side of
the Top Trim (one screw
per side for Collared
top trim) with a Phillips
screwdriver to the
cabinets (Fig. 22).
c.
Repeat for the left side.
Side Trim Installation For:
TRMKTEZ2FL75 (Frigidaire)
TRMKTEZ2LV79 (Frigidaire)
TRMKTEZ2FL79 (Frigidaire)
TRMKTSS2FL79 (Electrolux)
24. a.
Place side trims in
position by dropping
them over the placement
screw as seen in Fig. 21
and fitting over the top
trim (Fig. 23).
Electrolux TRMKTSS2LV84 Side Trim Installation
25. a.
Slide the left Side Trim
into place by carefully
guiding the Side Trim
Attachment slots. Fig. 24
shows an inside view.
b.
26. a.
b.
Fig. 21
Fig. 22
Fig. 23
Fig. 24
©2021 Electrolux Home Products, Inc.
INSTRUCTION SHEET
Fasten 2H screws to
the top trim (Fig. 25)
and repeat for the right
hand side.
Carefully place the Toe
Kick over the 4 Leveler
Assembly Slots. The first
Leveler Assembly slot
is circled in Fig. 26, and
the fourth Leveler
Assembly slot is circled
in Fig. 27.
Adjust the Toe kick until
the magnets are
engaged to the Leveler
Assembly bolts and the
Toe Kick is resting
vertically in place.
Instruction Sheet A00343905
Fig. 25
Fig. 26
Fig. 27
7.23.21

Advertisement

loading