Restoring The System From The Hard Disk - Fujitsu SCALEO E Manual

5. Under "User name:" enter the user names and the "Password". The user name
will also be available in the selection menu and can be called up by clicking on the
black triangle. If you have not assigned a password for the user selected, leave the
"Password" field empty. Then click on "OK".
6. In the following "System Recovery Options" menu, select the option "Fujitsu
Siemens Computers Recovery" with the sub-item "Easy backup and recovery
of your system".
7. The "Backup / Restore data" menu will open. Select "Back up factory default
settings" and click on "Next".
8. This will give you access to the DVD burner, click on "Next".
9. Select a storage medium under "Select type of disk", click on "Next".
10. You will then be asked to name the medium. Name the medium as suggested on
screen (e.g. "Recovery # 1"). This labelling is necessary to ensure that the media
do not become mixed up during the restore process.
11. Insert the first disk in the drive of your burner and close the drive.
The burning process will start.
The duration of the process is dependent on the configuration of your system and
may therefore take several minutes.
12. When prompted, insert the next disk into the drive.
On completion of the writing process, a confirmation message will be displayed.
13. Remove the disk from the drive.
14. Select "Exit" to close the process.

3.2 Restoring the system from the hard disk

Your personal data could be lost during restoration of the factory default settings. The
operating system is restored on the system partition on which the factory default
settings were installed. Data on other partitions or hard disks is unaffected by this
restore processes. Should your system be attacked by 'uninvited guests' from the Net,
such as viruses, reformat all hard disks and restore your system with the system restore
disks provided with the computer or which you have created.
Caution If you would like to set up a RAID system on your PC or notebook, you must
create your system restore disks before you do so.
If you need to use these disks, it may first be necessary to terminate the
RAID connection.
Please also note that, in the case of RAID systems already installed, it is
possible that restoring the hard disk as described below may not function.
Caution! Personal data could be lost during restoration of the factory default settings.
Proceed as follows to restore the factory default settings:
1. Turn your machine on
or:
If the PC is already running, switch the machine off, wait for a moment and then
switch it on again.
2. During the boot process, press the F8 key at very frequent intervals, until the menu
"Advanced Boot Options" appears. Repeat this process if necessary in order to
gain access to this menu.
4
.com