Powermanager Function; Cleaning And Servicing - Siemens EH Series User Manual

en PowerManager function
14

PowerManager function

You can use the PowerManager function to set the total
power of the hob.
The hob is set at the factory; the hob's maximum power
is shown on the rating plate. You can use this function
to adjust the configuration to the requirements of each
electrical installation.
In order to not exceed this set value, the hob automat-
ically distributes the available power as needed
between the cooking zones that are switched on.
15

Cleaning and servicing

To keep your appliance working efficiently for a long
time, it is important to clean and maintain it carefully.
15.1 Cleaning products
You can obtain suitable cleaning products and glass
scrapers from customer service, the online shop or a
retailer.
ATTENTION!
Unsuitable cleaning products may damage the sur-
faces of the appliance.
Never use unsuitable cleaning products.
▶
Do not use cleaning products while the hob is still
▶
hot. This may cause marks on the surface.
Unsuitable cleaning products
¡ Undiluted detergent
¡ Detergent intended for dishwashers
¡ Abrasive cleaners
¡ Aggressive cleaning products such as oven spray
or stain remover
¡ Abrasive sponges
¡ High-pressure or steam jet cleaners
15.2 Potential stains
In order to avoid these stains, clean the hob with a
damp dish cloth and dry it with a cloth.
14
While the PowerManager function is activated, the out-
put of a cooking zone may temporarily fall below the
nominal value. In order to not exceed this set value, the
hob automatically distributes the available power as
needed between the cooking zones that are switched
on . The appliance regulates and selects the highest
power level automatically.
For more information, go to
→ "Basic settings", Page 12
Dam- Cause Action
age
Stains Limescale Only clean the hob when it has
and water cooled down sufficiently.
marks You can use a cleaning agent
suitable for glass-ceramic hobs.
Stains Sugar, rice Clean immediately.
starch or Use a glass scraper.
plastic
15.3 Cleaning the hob
Clean the hob after every use to stop cooking residues
from getting burnt on.
Note: "Note the information on unsuitable cleaning
products." → Page 14
Requirement: The hob has cooled down.
Remove heavy dirt using a glass scraper.
1.
Clean the hob with a cleaning product for glass
2.
ceramic.
Follow the cleaning instructions on the product
packaging.
Tip: You can achieve good cleaning results if you
use a special sponge for glass ceramic.
15.4 Cleaning the hob surround
If the hob frame is dirty or stained after use, clean this.
Notes
¡ "Observe the information on unsuitable cleaning
products." → Page 14
¡ Do not use a glass scraper.
Clean the hob frame with hot soapy water and a soft
1.
cloth.
Wash new sponge cloths thoroughly before use.
Dry with a soft cloth.
2.