Toro Reelmaster 3100-D Service Manual page 183

Disassembling the Reel Motor
Reelmaster ® 3100-D/3105-D
20252SL Rev A
(Figure 84) (continued)
g345531
1. Marker line
2. Use a marker to make a diagonal line across the front flange, body and rear
cover for assembly purposes
Prevent damage when clamping the motor into a vise; use a vise
with soft jaws and clamp on the front flange only.
3. Clamp the front flange of motor in a vise with soft jaws with the shaft end
down.
4. Loosen the cap screws from the rear cover.
5. Remove the motor from the vise. Turn motor so that the shaft end is facing
down and remove cap screws.
6. Carefully remove the rear cover. Remove and discard the O–ring from the
body. Locate and retrieve dowel pins.
7. Carefully remove body. Lift body straight up to remove. Make sure that the
rear wear plate remains on the drive and idler gear shafts. Remove and
discard O–ring from the body. Locate and retrieve dowel pins.
Record position of the open and closed side of the wear plates
before removing. Identify wear plates (inner and outer, drive gear
and idler gear) with a marker for proper assembly.
Mark the relative positions of the gear teeth so they can be
reassembled in the same (mated) position. Do not touch the gear
surfaces as residue on hands may be corrosive to gear finish.
8. Carefully disassemble the inner wear plate, idler gear, drive gear and outer
wear plate.
Figure 85
(Figure 85).
IMPORTANT
IMPORTANT
IMPORTANT
Page 5–107 Hydraulic System: Service and Repairs