E1101
To replace the backlight of E1101, follow the steps 1-5 in section
Cover
for E1101. Then follow the steps below:
1. Gently move the backlight diagonally in direction from the display center to
release the snap-in closure that keeps the backlight in place.
2. Remove the backlight from the display.
3. Insert the new backlight. Be careful not to pull the cables of the new backlight
when inserting it, since pulling the cables will damage the backlight.
4. Re-assemble the complete operator panel.
E1151
To replace the backlight of E1151 you will need two new backlights, see the
Available Spare Parts
Follow the steps 1-5 in section
steps below:
1. Remove the two cross-headed screws to the backlight, using the Phillips size 00
screwdriver. This way, backlights can be removed without removing the plate.
2. Remove the backlights.
3. Insert the new backlights. Be careful not to pull the cables of the new backlights
when inserting them, since pulling the cables will damage the backlights.
4. Re-assemble the complete operator panel.
Mitsubishi Electric, MA00758A
backlight snap lock
list.
Replacing the Rear Cover
2 x cross headed screw
Replacing the Rear
backlight
connectors
for E1151. Then follow the
2 x backlight
Hardware
43