36in Recycler
Proline Commercial Walk-Behind Mower with 36in Floating Cutting
Unit
Model No. 140-1913
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
3
4
5
1
Preparing the Machine
No Parts Required
Procedure
1.
Park the machine on a level surface.
2.
Disengage the PTO, engage the parking brake.
3.
Shut off the engine and remove the key.
4.
For easier access, raise the front of the machine
and support it using jack stands rated for your
machines.
WARNING
Mechanical or hydraulic jacks may fail to
support the machine and cause serious
injury.
Use jack stands when supporting the
machine.
© 2019—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
Description
Trailing shield
R-clamps
Bolt (5/16 x 3/4 inch)
Nut (5/16 inch)
Left baffle
Right baffle
Discharge plate
Bolt (3/8 x 1 inch)
Nut (3/8 inch)
Mulching blade
Register at www.Toro.com.
Kit
Qty.
1
2
2
1
1
1
9
9
3
2
Preparing the Mower Deck
No Parts Required
Procedure
1.
Remove the existing mower blades; refer to the
Operator's Manual for the machine.
2.
Remove the 2 bolts and 2 nuts securing the
baffle to the deck and remove the baffle
1).
Note:
Retain the baffle for converting back to
side discharge.
Form No. 3436-316 Rev A
Installation Instructions
Use
Install the trailing shield.
Install the kit.
Install the mulching blades.
Original Instructions (EN)
All Rights Reserved *3436-316* A
Printed in the USA.
(Figure