Wall Bracket (Optional); Electrical Connection - Miele PAC 1045 Operating Instructions Manual

Wall bracket (optional)

To provide extra protection against the air purifier tipping over, you can secure it to a wall
using the bracket provided if necessary.
Mounting the wall bracket (optional)

Electrical connection

The air purifier is supplied with a mains cable with moulded plug ready for connection to
an earthed socket as standard.
The socket must be easily accessible after the air purifier has been installed. If the socket
is not easily accessible, ensure that a suitable means of disconnection is provided on the
installation side for each pole.
 Risk of fire from overheating.
Connecting the air purifier to multi-socket adapters or extension cables can overload the
cables.
For safety reasons, do not use an extension cable or multi-socket adapter.
The electrical installation must comply with VDE 0100 requirements.
For safety reasons, we recommend using a type A residual current device (RCD) in the as-
signed electrical installation for connecting the air purifier.
If the mains connection cable is damaged, it must only be replaced with a specific mains
connection cable of the same type (available from the Miele Customer Service Depart-
ment). For safety reasons, such replacement may only be carried out by a qualified spe-
cialist or the Miele Customer Service Department.
These operating instructions and the data plate indicate the nominal power consumption
and the appropriate fuse rating. Compare this information with the data of the on-site elec-
trical connection.
If in any doubt, consult a qualified electrician.
Do not connect the air purifier to a stand-alone inverter such as those used with an
autonomous energy source, e.g. solar power. When the air purifier is switched on, power
surges could result in an auto switch off. This could damage the electronic module.
en - Installation
55