Charging; Operation - Silvercrest SHBS 3.7 A1 Operating Instructions Manual

BB.5$ B%ERRN 6HLWH  0LWWZRFK  'H]HPEHU    

5. Charging

NOTES:
• Before first use (without cable), and for every charging
procedure afterwards, charge the hair and beard trim-
mer|5 for approx. 90 minutes.
• When the batteries are nearly empty, the charging indica-
tor|8 flashes red during operation. The device can then
only be used for a short time without being connected to
the electricity supply.
1. Place the battery charger|10 on a level surface.
2. Connect the power unit|9 to the battery charger|10.
3. Switch off the device with the on/off switch|7 if necessary.
4. Insert the power unit|9 into a readily accessible wall sock-
et whose voltage matches the voltage stated on the rating
plate.
5. Put the hair and beard trimmer|5 into the battery charg-
er|10.
6. The charging indicator|8 is lit red and the battery is
charged. When the battery is fully charged, the charging
indicator is lit green. When the battery is fully charged,
the device can be used for approximately 60 minutes with-
out being connected to the power supply.

6. Operation

Regardless of the charging state of the battery, the 5in1 hair and
beard trimmer can always be mains-operated.
1. For mains operation, ensure that the hair and beard trim-
mer|5 is switched off.
2. Connect the power unit|9 to the connector of the hair and
beard trimmer|5.
3. Insert the power unit|9 into a readily accessible wall sock-
et whose voltage matches the voltage stated on the rating
plate.
4. Switch on the device with the on/off switch|7.
10 GB