Toshiba RAS-B10 Owner's Manual page 8

9.7 PLASMA ION OPERATION
Capture efficiency of floating impurities in the air is accelerated by plasma ion
contaminates such as bacteria, odor, smoke, dust and virus are caught and
deactivated by Plasma Ion.
1. Press MENU button for enter menu setting and press TEMP. button to
select PURE
MENU
2. Confirm selected feature by press MENU button again.
MENU
3. Leave from menu setting display by select EXIT.
MENU
Note:
● Plasma Ion operation dose not remove harmful substances from cigarette
smoke (carbon monoxide etc.). Open a window occasionally for ventilation.
9.8 POWER-SELECTION OPERATION
To automatically control room temperature to save energy (except in DRY and
FAN ONLY mode)
1. Press MENU button for enter menu setting and press TEMP. button to select
POWER-SEL
MENU
2. Enter POWER-SEL setting by press MENU button again.
MENU
3. Select POWER-SEL level by press TEMP. button.
100% 75%
4. Confirm POWER-SEL level by press MENU button.
MENU
5. Leave from menu setting display by select EXIT.
MENU
PURE
Blink both triangle and
°C
feature mark Feature not
°C
yet set
°C
Blink only triangle Feature
already set
°C
°C
°C
Blink only triangle
°C
°C
50%
°C
°C
MANUAL DEFORST OPERATION
10
To defrosting the heat exchanger of the outdoor unit during Heating operation
Press and hold : for 5 seconds , then remote control display will
MENU
show as picture 1 for 2 seconds.
DISPLAY LAMP BRIGHTNESS ADJUSTMENT
11
To decrease the display lamp brightness or turn it off.
FAN
1. Press and hold
or ) is shown on remote control LCD then release the button.
2. Press or
Rise
Decrease
Remote control
Operation display
LCD
Lamp illuminates full brightness.
Lamp illuminates 50% brightness.
Lamp illuminates 50% brightness and the
operation lamp is turned off.
All lamps are turned off.
● In the examples of
and , the lamp illuminates for 5 seconds before going off.
AUTO RESTART FUNCTION SETTING
12
This product is designed so that, after a power failure, it can restart automatically
in the same operating mode as before the power failure.
Information
The product was shipped with Auto Restart function in the OFF position.
Turn it ON as required.
How to turn ON the Auto Restart Function
● Press and hold the [OPERATION] button on the indoor unit for 3 seconds
(3 beep sounds and OPERATION lamp blink 5 time/sec for 5 seconds).
How to turn OFF the Auto Restart Function
● Press and hold the [OPERATION] button on the indoor unit for 3 seconds
(3 beep sounds but OPERATION lamp does not blink).
Notes :
● In case of ON timer or OFF timer are set, AUTO RESTART OPERATION
does not activate.
SELF CLEANING OPERATION
13
(COOL AND DRY OPERATION ONLY)
To protect bad smell caused by the humidity in the indoor unit.
1. If the button is pressed once during "Cool" or "Dry" mode,
the fan will continue to run for other 30 minutes, then it will turn off
automatically. This will reduce the moisture in the indoor unit.
2. To stop the unit immediately, press the
seconds.
1
for 3 seconds until brightness level (
to adjust brightness in 4 levels.
Brightness
All turned off
more 2 times within 30
, ,
100%
50%
50%