Table of Contents
Advertisement
Location and Function of Parts and Controls
4 SIGNAL switch
Use this switch to select the following modes:
2N : The same field signals (ODD/EVEN) are output
continuously for 1/60 sec. from the VIDEO OUT 1
and VIDEO OUT 2 connectors.
2I : The ODD/EVEN signals are output in the interlace
mode for 1/60 sec. from the VIDEO OUT 1 and
VIDEO OUT 2 connectors.
1N : The non-interlace signal is output only from the
VIDEO OUT 1 connector for 1/30 sec.
Note
In 1N mode, no video signals are output from the
VIDEO OUT 2 connector.
5 LENS (lens/external control) connector (6-pin)
The lens cable of an auto-iris lens plugs into this connector
for automatic iris control. Use this connector to input an
external trigger pulse or output a WEN (Write ENable)
pulse when you use the E-DONPISHA mode or Restart/
Reset mode. The pin configuration of this connector is as
follows:
6
1
5
2
4
3
58
Pin no.
Signal
1
Control input/
FLD pulse output
2
Ext. trigger input
3
Ground
4
WEN pulse output
5
AI video signal output
6
+12 V DC
Note on pin no. 1
Factory setting: Control input
When you need normal video output when in the E-
DONPISHA mode, ground pin no. 1 (set to low voltage).
For details, contact the store of purchase or your
authorized Sony dealer.
6 VIDEO OUT (output) 1 connector (BNC-type)
Outputs video signal 1 from the camera module.
7 VIDEO OUT (output) 2 connector (BNC-type)
Outputs video signal 2 from the camera module.
Advertisement
Chapters
Table of Contents
