Sealey MK51.V2 Instructions

thank you for purchasing a sealey product. Manufactured to a high standard this product will, if used according to these instructions and properly maintained, give you years
of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUcTIONS cAREfULLy. NOTE THE SAfE OPERATIONAL REQUIREMENTS, WARNINGS, AND
cAUTIONS. USE THIS PRODUcT cORREcTLy, AND WITH cARE fOR THE PURPOSE fOR WHIcH IT IS INTENDED. fAILURE TO DO SO
MAy cAUSE DAMAGE AND/OR PERSONAL INJURy AND WILL INVALIDATE THE WARRANTy.
1. SAfETy INSTRUcTIONS
 Only use on firm, level, unobstructed surfaces which are capable of supporting the stand and body panels.
 DO nOt overload.
 Always load evenly with the centre of gravity of the load as near the centre as possible.
 Apply the brakes before commencing work.
 DO nOt stand/ride on the stand, or allow others to do so.
 replace or repair damaged parts. use only recommended parts. unauthorised parts may be dangerous and will invalidate the warranty.
 WARNING! Failure to comply with these instructions may result in loss of load, damage to the stand or other property and/or personal
injury.
 WARNING! The warnings, cautions and instructions discussed in this instruction manual cannot cover all possible conditions
and situations that may occur. It must be understood that common sense and caution are factors which cannot be built into this
product, but must be applied by the operator.
2. INTRODUcTION & SPEcIfIcATION
Features fully adjustable arms to fit many styles of bonnets, wings, doors and bumpers. Main frame can adjust through 180°, to give required angle.
Fitted with two fixed Ø 180mm wheels and two braked Ø 125mm castors for easy manoeuvrability.
Specification
Overall Arm Width: . . . . . . . . . 935mm
Base Dimensions: . . . . . . . . . . 1110 x 780mm
3. ASSEMBLy
Assemble panel stand according to the diagram overleaf.
instructiOns FOr:
PANEL STAND -
DOOR, WING, BONNET & BUMPER
MODel nO: MK51.V2