Mount Control Panel On The Wall - Honeywell AQ250 Series Quick Installation Manual

CONTACTS
SYMBOL
Fig. 2 Internal wiring for AQ2000 Series components line voltage relays

4 Mount Control Panel On The Wall,

Along With Any Expansion Zoning
Panels
When Installing this Product
• Read these instructions carefully. Failure to follow them
could damage the product or cause a hazardous condition.
• Check the ratings given in the instructions and on the
product to make sure the product is suitable for the
application.
• Installers must be trained, experienced, licensed service
technicians.
• Follow local codes for installation and application.
• After installation is complete, check out product operation
as printed in these instructions.
WIRE
CHANNEL
PLUGS
Fig. 3 Orientation of Wire Channel Plugs for Creating pass-through wire channel and
WIRE
CHANNEL
PLUGS
for Joining Control Panel to Expansion Zoning Panels
3
AQ250 SERIES HYDRONIC CONTROL PANELS
ZR Boiler DHW
Aux
1. Use template supplied with the AQ250 Control Panel to
mark the four mounting holes for the panel.
2. Install two top screws, mount panel and then install two
lower screws.
If there are Expansion Zoning Panels to install, they should be
mounted on the wall now. If not, skip this section and proceed
to Step 5 "Mount Thermostats In The Zones".
3. Remove wire channel plugs from the AQ250 Control
Panel and any Expansion Panels (see Figure 3).
4. Mount Expansion Zoning Panel on the right hand end of
the AQ250 Control Panel. Install two top screws of the
Expansion Zoning Panel, ensuring it is level with the
adjoining Control Panel, and install two lower screws.
5. Reverse wire channel plugs and re-insert them into their
slot to from a wiring channel between the Control Panel
and the Expansion Zoning Panel (see Figure 3) and to
connect the two panels together.
6. If there are additional Expansion Zoning Panels, repeat
Steps 3-5 above.
Zone 1 Zone 2 Zone 3 Zone 4
M13896
M23733A
69-1982