Local/Remote Key - Siemens SINAMICS G130 Operating Instructions Manual

5.7.1

LOCAL/REMOTE key

Activating the LOCAL mode: Press the LOCAL key.
LOCAL mode: LED lights up
REMOTE mode: LED does not light up: the ON, OFF, JOG, direction reversal, faster, and
slower keys are not active.
Settings: MENU – Commissioning/Service – AOP Settings – Control Settings
Save LOCAL mode (factory setting: yes)
● Yes: The "LOCAL" or "REMOTE" operating mode is saved when the power supply is
● No: "LOCAL" or "REMOTE" operating mode is not saved. "REMOTE" is active when the
OFF in REMOTE (factory setting: no)
● Yes: The OFF key functions in REMOTE mode even if the drive is being controlled by
● No: The OFF key only functions in LOCAL mode.
LOCAL/REMOTE also during operation (factory setting: No)
● Yes: You can switch between LOCAL and REMOTE when the drive is switched on (motor
● No: Before the system switches to LOCAL, a check is carried out to determine whether
The AOP30 operator panel
Operating Instructions, 03/2012, A5E00331451A
switched off and restored when the power supply is switched back on.
supply voltage is switched back on.
external sources (PROFIBUS, customer terminal strip, NAMUR terminal strip).
WARNING This function is not an EMERGENCY STOP function!
is running).
the drive is in the operational status. If so, the system does not switch to LOCAL and
outputs the message "Local not possible". Before the system switches to REMOTE, the
drive is switched off and the setpoint is set to 0.
Control via the operator panel
5.7 Operation via the operator panel (LOCAL mode)
35