Post Error Messages - NEC Express5800 Series User Manual

Chapter 3 Setup
Example: If the jumper setting for an on-board RAID Controller is enabled
Press <Ctrl> <M> to Run LSI Software RAID Configuration Utility
The utility starts by pressing the <Ctrl> + <M> keys.
For details on the utility, refer to the manual supplied with each optional board.
Depending on the configuration, the message "Press Any Key" might appear to prompt a key entry. This is a
behavior of the BIOS of the optional board. Continue to operate after checking the manual of the optional board.
6. If you have set the password using the BIOS SETUP utility, the password entry screen appears upon successful
completion of POST.
Up to three password entries will be accepted. Three incorrect password entries disable the system to boot. In
such a case, turn off the power and wait about 10 seconds before turning on to boot the CPU blade.
Important
7. The OS starts when POST completes.

1.5.2 POST Error Messages

When POST detects an error, it displays an error message on the screen. For descriptions of error messages,
causes, and countermeasures, refer to "Maintenance Guide".
Important
88
Do not set a password before installing an OS.
Take notes on the messages displayed before consulting with your maintenance
service company. Alarm messages are useful information for maintenance.
Express5800/B120d, B110d User's Guide
1. Power-on of Blade Server