Table of Contents
Advertisement
INSTALLATION
Debug Port and Factory Reset
Along the bottom side of the controller is a debug port for serial debug communications and a Factory Reset button. See the MS-E10
Install and Startup Guide for information on setting the controller to factory defaults.
The DEBUG port is a standard Micro-USB AB port for serial debug communications to the controller. Use a serial terminal program (for
example: PuTTY) to access the controller "system shell" menu. This provides access to some basic platform settings.
Default DEBUG port settings are: 115200, 8, N, 1
(baud rate, data bits, parity, stop bits). For details on using a serial connection to the DEBUG port, see the MS-E10 Install and Startup
Guide.
Tab Mounting option
6.71 in. (170.5 mm)
0.153 in. Dia.
(3.878 mm)
0.330 in.
(8.378 mm)
6.38 in. (162 mm)
7.05 in. (179 mm)
DIN rail mounting is recommended. Where tab mounting is required, use dimensions in the illustration to mount the controller.
NOTE: Do not mount hardware on both a DIN Rail and with tab mounts to another surface. This causes physical stress on
equipment.
MS-E10 Controller. Allow at least 1.5" (38mm) clearance around all sides.
1
18
3.75 in.
(95.25mm)
1
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG" is a registered trademark of LG Corp.
3.31 in.
(84 mm)
4.33 in.
(115 mm)
Hide quick links:
Advertisement
Table of Contents
