Replacing The Filter - Silvercrest SLR 30 A1 Operating Instructions And Safety Instructions

Replacing the filter
RISK OF ELECTRICAL SHOCK!
► Always switch off the appliance and unplug it from the mains before chang-
ing the filter!
NOTE
► The interval for a filter change is approx. 1500 operating hours.
► Information on ordering replacement filters can be found in the next section
Ordering spare parts.
When the filter
by the flashing of the filter change button
replace it with a new filter
1. Switch off the appliance and pull out the mains plug.
2. Turn the appliance upside down to access the bottom of the unit.
3. Turn the housing cover
anticlockwise in the OPEN
the housing cover
Fig. 3
4. Remove the filter
appliance.
5. Replace the housing cover
on the edge of the lid opening.
6. Turn the housing cover
til it is closed (see fig. 4). Turn the appliance back over.
7. Press the filter change button
change and reset the filter timer. You will hear a beep, the filter change button
3
SLR 30 A1
8
has reached the end of its life and is used up, this is indicated
8
, proceed as follows:
9
on the bottom of the appliance a little way
9
from the appliance.
8
from the appliance and insert a new filter
9
9
clockwise a little way in the CLOSE
flashes three times and then goes out.
3
. To change the filter
direction to open it (see fig. 3). Then remove
Fig. 4
onto the appliance. Pay attention to the recesses
3
for about 3 seconds to confirm the filter
8
and
8
into the
direction un-
GB │ CY │
13 ■