Hitachi EC702HP Operation Manual page 79

Section 3 - Installation (ATSC EC702HP Transmitter)
D- Programming
a. The transmitter is ready to receive ASI transport streams as programming source.
b. Programming BNC connector is located on the top panel of the transmitter.
c. Connect the applicable signal cables on the top cover of the rack.
Manual Rev. 0.0 - April 2016
RF AFTER FILTER IN A
GPS ANTENNA IN A
ASI 1 INPUT
ASI 2 INPUT
ASI 1 OUTPUT
External 10MHz
reference
Connections Panel - Transmitter
Figure 3-57
3-44