Table of Contents
Advertisement
Tank
(Once a month)
Tank, tank cover and water outlet
Rinse these parts 2 or 3 times with tap water.
●
For stubborn stains, use water mixed with a small
amount of mild kitchen cleanser.
●
To remove the tank cover, first open the water
outlet, then lift the tank cover upward to remove it.
(Do not pull on the water outlet. Doing so may
damage the water outlet.)
●
Depending on where you use the dehumidifier, the
inside of the tank may become especially dirty due
to the dirt and dust in the air.
Float
Clean the slime without removing the float.
●
Remove the dirt around the two axles.
(Keeping these areas clean will prevent the float
from malfunctioning.)
●
Do not remove the float.
If the float is removed, the unit will not operate.
If the float is not attached properly, water may leak.
●
If the float comes off
Insert the float axles into the matching holes as
shown. Match the axle sizes with the hole sizes to
ensure that the float is installed in the correct
direction.
When not using the unit for long periods of time
1
Water remaining inside the unit continues to
accumulate in the tank, so empty the tank one
day after the unit is turned off. (
2
Clean the main unit, tank and filter.
(
page 22, 23)
3
Cover the unit with a plastic bag.
4
Store the unit upright in a dry and well-
ventilated place.
Important
●
Store the unit upright in a flat and stable location.
(Do not lean the unit against something or lay it down.
Doing so may result in a breakdown, or cause any water
remaining inside the unit to leak out.)
Water outlet
1
Do not pull
on the water
outlet.
Holes
page 21)
Do not pull on the power cord when
storing away the dehumidifier.
It may cause a short-circuit or damage the
wires inside the cord, and fire or electric
shocks may occur.
How to use
Tank cover
Tank
Open the
Lift the tank cover
2
water outlet.
upward.
Axles
WARNING
No!
Tank
handle
Float
Float
23
YHC12X
Hide quick links:
Advertisement
Chapters
Table of Contents
